9
GB
GB
Preparation procedures before using this product
1 Remove all packaging components
The foam base and adhesive tape for holding the accessories
must also be removed.
2 Count attached accessories and data
Please check articles in the package according to the details
of the packing list. If there are discrepancies, please consult a
salesperson.
3 Place the appliance in the place where
the following conditions are met:
• The space surrounding the appliance should include a space
of 10 cm or more in the rear.
• The appliance should be placed on solid ground. If
packing is needed, a smooth, hard and pad
should be selected. If it is a little unstable, adjust the black
adjustable feet at the front of the appliance:
→ Rotate clockwise to increase the height of the appliance.
→ Rotate counterclockwise to reduce the height of the
appliance.
Caution
To prevent the appliance from rolling forward during use, please
adjust the adjustable feet so that they are in full contact with the
ground in order to secure the appliance’s position.
Do not use the packing foam base for the appliance to pad the
appliance.
4 Clean before use
(For cleaning method, see "Cleaning of the appliance" on page
21, "Cleaning the water reservoit assembly" on page 19 and
"Cleaning the ice cube tray" on page 20.)
5 Standing
After placing, leveling and cleaning of the appliance, do not
switch on. Leave the appliance stand for 5 hours or more,
then switch on the appliance with the power plug to ensure the
normal operation of the appliance.
6
Before use, please peel off the transparent on the
side panel so as not to affect the normal cooling and power
consumption of the appliance.
10 cm or more above
10 cm or more
in the rear
10 cm or more
to the left
10 cm or more
to the right
Adjustable
feet
Raise Lower
The 2 packing wedges below each door must be removed
before using the appliance. The packing wedges are only used
to protect the appliance during transportation.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
