Front Load Washer Model:HBF600T
VI .The water level is too high.
Possible causes
1.Gas leakage at pressure system of water supply.
2.The pressure switch is broken.
Troubleshooting
1.Check whether the pipeline of pressure system is blocked or there is gas leakage. The pressure system
includes:
(1) Gas-collecting valve
(2) Rubber pipe
(3) Pipe clip2.Blow on the pressure switch and "click, click" can be heard. Otherwise, replace the pressure
switch with a new one.
VII .No heating or automatic heating
Possible causes
1.Thermostat breakdown
2.Effect of ambient temperature
3.The water-heating pipe is broken.
1.Check whether the knob of temperature controller clicks at room temperature. If not, make necessary
replacement.
Note:
1).The temperature controller breaks down when it is cold and no click can be heard. Warm the room and
the temperature controller will get normal.
2).The water is automatically heated when it is cold and the temperature knob is at "0" position. The
process stops when the water is about 30°C.
2.Check the water-heating pipe to see whether the resistance wire is normal. If not, make necessary
replacement.
VIII .Water leakage
Possible causes
1.Leakage at joints
2.The reinforcement of outer cylinder is poorly welded.
3.There is foreign object on the cushion of sight window.
Troubleshooting
1.Check whether the joints are damaged or loose.
1).Filling pipe
2).Hose connecting electromagnetic valve to dispenser
3).Hose connecting dispenser to outer cylinder
16
To Next Page
Loading...
Need help?
General
