Front Load Washer Model:HBF600T
4).Cushion of sight window
5).Hose connecting outer cylinder to pump
6).Drainage pump
7).Gas-collecting valve
8).Dispenser
9)Condenser
10) Hose connecting condenser to hose of outer cylinder
2.For leakage resulting from the welding defect of outer cylinder, replace the outer cylinder.
3.Wipe off the foreign object from the cushion of sight window.
IX .Improper distribution of dispenser
Possible causes
1.The extension spring loses.
2.Misfit of eccentric wheel, follower and liner
3.Fault of gear of dispenser
Troubleshooting
1.Reassemble the extension spring
2.Reassemble the eccentric wheel, follower and the liner
3.Adjust the gear of dispenser
X . The outer case becomes live.
Possible causes
1.Whether the electric circuit is good.
2.The washer is not safely earthed.
3.The damaged rubber sheath of the power cord results in electric leakage.
Troubleshooting
1.Check whether the insulation of power cord is good. If not, make necessary replacement.
2.Earth the washer safely.
3.Check the condition of rubber sheath of the power cord and wrap the damaged parts with insulation
tape.
XI .The door lock indicator does not light.
Possible causes
1.The door lock indicator is broken.
2.The wiring of micro delay switch is loose.
3.The indicator loses.
Troubleshooting
1.Replace the broken indicator.
2.Tighten the stub of micro delay switch.
3.Refasten the indicator.
17
18
To Next Page
Loading...
Need help?
General
