1. DRILLING FOR PIPING
(Fig. 11)
Rear (Install the drain hose
in the direction.)
Right
(Fig. 12)
Insert the anchor bolts into the drilled holes, and drive the pins
2. DRILLING HOLES FOR ANCHOR BOLTS AND INSTALLING THE ANCHOR BOLTS
When the directions are selected, drill 80mm and 50mm or 150mm dia. hole on the wall so that the hole is tilted
downward toward the outdoor for smooth water flow.
Wall
6mm
60 to 70mm
12.7mm
(Fig. 13)
Install the drain hose at the rear; it should not be installed on the top or right side.
CAUTION
3. INSTALLING BRACKETS
(Fig. 14)
4. INSTALLING INDOOR UNIT
completely into the anchor bolts with a hammer.
(Fig. 13)
Install the brackets with nuts, washers and spring washers.
(Fig. 14)
With a concrete drill, drill four 12.7 mm dia. Holes.
(Fig. 15)
(Fig. 15)
Reset the hex bolts as shown in
.
Fig.16
NX^XVf b\b\`Z T`W WdT\` W\dXVf\a`e1 Cad eXd\Xe 5;1a`^k dXTd e\WX -C\Z144.
Nbd\`Z iTe[Xd
NbXV\T^ `gf
?dTV]Xf
Cad eXd\Xe 5;
?dTV]Xf -M\Z[f.
?dTV]Xf -HXYf.
Cad eXd\Xe 4;
9;
49 54 5;
6;4
565
5918
5918
50M518
43
4;
:18
70M8
9;
49
54
5;
6;4
565
5918
5918
50M518
43
4;
:18
70M8
Installation
To Next Page
Loading...
Need help?
General
