INSTALLATION INSTRUCTIONS
Please read and follow the ‘Safety and warnings’ and ‘Installation
instructions’ sections carefully before using your dryer.
Unpacking
1 Remove all the packaging.
2 Tilt the dryer backwards and ‘walk’ it off the base one foot at a time.
3 Remove all packaging and accessories from inside the drum and ensure you
remove protective covers from the door and console.
IMPORTANT!
■ Ensure packaging materials are kept out of reach of children.
■ Please help protect the environment and dispose of the packaging from around
the dryer in an environmentally friendly manner.
Accessories
Please check your dryer model and the following accessories inside the drum:
Location
IMPORTANT!
■ The dryer must be installed in a well-ventilated, dust-
free environment.
■ The dryer must not be installed on any textured floor
coverings (eg carpet, rugs).
■ Do not install the dryer behind a lockable door, sliding
door, or behind a door where the hinge is on the
opposite side to that of the dryer in such a way that the
full opening of the door is inhibited. Ensure the dryer
door can always be opened fully.
■ Do not install the dryer outside, in a damp place, where
there is a risk of freezing, where it may be rained on, in
direct sunlight or close to a source of heat.
■ Do not place your dryer on top of its power cable.
HDV70E1
■ 1 x Installation in
structions
and user guide
■ 1 x Wall mounting kit
■ 2 x Stacking bracket
■ 1 x Hose connector
■ 1 x Flexible hose
■ 1 x Flexible hose clip
■ 1 x Inverted panel
■ 1 x Warranty card
5
To Next Page
Loading...
Need help?
General
