Haier HLP21 - Quick Set-Up Instructions for Normal Wash; Locating the Washer; Connecting Water and Drain

yltceridro,gnitttcennockciuQehtgnisu,esohtelniretawehttcennoC.3
connect to faucet.
.kooHniarDehtgnisuknisehtedisnironia
rdniesohniardecalP.4
.murdehtfoedisehtnodellatsnisitI.ecalpnisiretltnilehterusekaM.5
aotnidrocrewopgulpneht,rehsawehtnisignihtolctubgnihtonerusnE.6
15 AMP 110-120 VOLT, 60 HZ GROUNDED OUTLET ONLY.
7. Proceed by pressing the "POWER ON" button.
8. Select water height.
ehtsserpneht,nottub”ELCYC“ehtgnisugnihsaw”LAMRON“tcel
eS.9
"START" button.
Power
English
9
NORMAL
WASH
WATER
LEVEL
START
_
PAUSE
LAMRONROFSNOITCURTSNIPU-TESKCIUQ
WASH
.rehsawelbatroptcapmocWENruoygnisurofecalptsebehtetacoL.1
Make sure it is near a 120 volt outlet and a water source, like a sink,
with a drain.
FRONT
FACE TO FLOOR
CYCLE
Sink Faucet
Quick Sink
Faucet
Adapter
Silver Faucet
Connector
Washer
Water inlet hose
Drain hose
Rear View of Washer
Drain
Hook
SINK
2. Screw on the bottom plate with the six (6) screws provided.