Haier HPIMD25B - User Manual

Questions and Answers

C
Caleb HallAug 8, 2025
How to fix a Haier HPIMD25B Ice Maker when the power LED won't turn on?
- D
  Deborah CainAug 9, 2025
  If the power LED indicator on your Haier Ice Maker won't turn on, make sure the unit is properly plugged into a standard 120V, 60 Hz outlet. Also, verify that the outlet has power and that the circuit breaker hasn't tripped.
H
hesschristopherAug 13, 2025
Why is the “Ice Full” LED on my Haier HPIMD25B and how to fix it?
- W
  William SandovalAug 13, 2025
  If the “Ice Full” LED indicator is on, it signifies that the storage compartment is full. To resolve this, remove ice from the storage compartment using the dispenser.
J
Jessica CarlsonAug 18, 2025
Why is my Haier Ice Maker not making ice even though it's running?
- K
  Kathleen BaxterAug 18, 2025
  If your Haier Ice Maker is not making ice even though the cycle appears normal, it could be due to a few reasons: 1. The ambient or water temperature might be too high. Try operating the ice maker at an ambient temperature below 90°F and use colder water in the reservoir. 2. There may be a refrigerant liquid leakage. In this case, turn the power off, unplug the unit, and contact a qualified technician. 3. The pipe in the cooling system could be blocked. Similarly, turn the power off, unplug the unit, and contact a qualified technician.
J
jamesrichardsonAug 23, 2025
What to do if the “Add Water” LED is on in my Haier Ice Maker?
- V
  Vanessa LucasAug 23, 2025
  If the “Add Water” LED indicator is illuminated on your Haier Ice Maker, it means the water reservoir is either empty or the water level is too low. Use the provided funnel to add water to the reservoir on the side of the unit.
C
Christina PaulAug 28, 2025
What to do if ice cubes are in the Haier HPIMD25B but won't dispense?
- W
  wallacejohnAug 28, 2025
  If your Haier Ice Maker is making ice but it's not coming out of the dispenser, there could be a couple of reasons: * The transparent hatch might be open. Ensure it is securely closed to reset the safety switch and reactivate the auger. * The auger in the ice storage compartment could be blocked. Release the ice dispenser paddle, wait 10 seconds, and then push the ice dispenser paddle forward again.
H
Holly MillerSep 3, 2025
What causes a solid block of ice to form on the evaporator in my Haier HPIMD25B Ice Maker?
- E
  Elizabeth WolfeSep 3, 2025
  If a solid block of ice forms on the evaporator of your Haier Ice Maker, it's likely due to incomplete ice dispensing from the storage compartment. To resolve this, unplug the unit and allow the ice to melt naturally. Never use a sharp object to remove the ice.