2
Outdoor Unit
Loading of the battery
1
2
3
4
Parts and Functions
Indoor Unit
OUTLET
INLET
CONNECTING PIPING AND ELECTRICAL WIRING
DRAIN HOSE
Remote controller
Remove the battery cover;
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
Be sure that the loading
is in line with th
e" + "/"-";
Load the battery,then put on the cover again.
Inlet grille
Inlet
Air Purifying Filter
Outlet
Horizontal flap
Display board
(adjust up and down air flow
Don't adjust it manually)
(adjust left and
ow)
Vertical blade
Emergency
Switch
Anion generator
(inside)
11.TIMER ON display
12.FAN SPEED display
LOW HI
MED AUTO
13. LOCK display
14. SWING display
Use to select CODE A or B
which will be displayed on
LCD.Please select A without
special explanation.
1.CODE
5.
7. MODE button
CLOCK button
15
.
SWING
When the remote controller
2.
RESET
button
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacle as well.
When electronic-started type fluorescent lamp or change- over
wireless telephone is installed in the
ver is apt to be disturbed in receiving
the signals,
so the distance to the indoor unit should be shorter
type fluorescent lamp or
room, the recei
Note:
Full display or unclear display during operation indicates the
ries have been used up.
Please change batteries.
If the remote controller can't run normally during operation, please
reload several minutes later.
batte
remove the batteries and
Remove the batteries in case unit won't be in usage for a long period.
If there are any display
after taking-out, just need to press reset key.
Hint:
appears abnormal,use a
sharp pointed article to
press this button to reset the
remote controller normal.
9
.
SLEEP display
10. ON/OFF button
6. HEALTH button
button
4.TIMER
button
Please be subject to the actual produce purchased the
above picture is just from your reference
right air fl
Please be subject to the actual produce purchased the
above picture is just from your reference
19
28
30
POWER/SOFT
3.LIGHT button
Control the lightening and
extinguishing of the indoor
LED display board.
8. HOUR button
16
.
HEALTH display
17. Operation mode display
Operation mode
AUTO
FAN
COOL DRY
Remote controller
HEAT
19
. POWER/SOFT display
20
. Left/right air flow display
21. TEMP display
22
. TIMER OFF display
23. CLOCK display
24
. TEMP button
25. FAN button
26. HEALTH AIRFLOW button
27
. SLEEP button
28. SET button
29. POWER/SOFT button
If pressed, the other buttons will
be disabled Press it once again,
lock will be cancelled.
30. LOCK button
18.Singal sending display
TEMP
display
COOL display
HEAT display
HE
ALTH display
Dry display
TIMER OFF display
TIMER ON display
SLEEP display
AUTO display
Remote signal receiver
Display board
Singal receiver hole
COOL display
HEAT display
TEMP display
Dry display
(If the unit which you purchased
has healthy function,follow it.
TIMER OFF display
TIMER ON display
SLEEP display
If not,please ignore.)
Display board
HEALTH display
The following displays are not available:
20
The following functions and related displays are only
4
19
29
available for model HSU-22HEA03/R2ǃHSU-24HEA03/R2 :