Haier HSU-09HEA03/R2 - annexe 2 - Heat Operation Guide; Heat Operation Mode; Heat Operation Hints

Press MODE button. For each press, operation
just press ON/OFF button and unit will run in previous status.
Hints
Remote controller can memorize each operation status. When starting it next time,
(5) Unit stop
Press ON/OFF button, the unit stops.
No reelecting is needed (TIMER ON/OFF SLEEP SWING needs reelcting)
(1) Unit start
mode changes as follows:
Press ON/OFF button, unit starts.
Previous operation status appears on display. (Not Timer setting)
(2) Select operation mode
(3) Select temp. setting
Press TEMP button.
Every time the button is pressed, temp. setting increases 1
o
C
Every time the button is pressed, temp. setting decreases 1
o
C
Unit will start running to reach the temp. setting on LCD.
Press FAN button. For each press, fan speed changes
(4) Fan speed selection
as follows:
AUTO LO MED HI
ON/OFF TEMP
SET
TIMER
CLOCKSWING
SLEEP
LOCK
RESET
FAN
MODE
HEALTH
1
2
3
4
3
5
Heat Operation
Remote controller:
Unit will run in operation mode displayed on LCD.
Stop display at your desired mode.
AUTO COOL DRY FAN
HEAT
IN HEAT mode, warm air will blow out after a short period
of the time due to cold-draft
prevention function.When FAN is set to AUTO, the air conditioner
automatically adjusts
the fan speed according to room temperature.
$
8
7
2
Operation
12