Comfortable SLEEP
Operation
Before going to bed, you can simply press the
SLEEP button and unit will operate in SLEEP
mode and bring you a sound sleep.
Use of SLEEP function
After the unit starts, set the operation status,
then press SLEEP button before which the
clock must be adjusted and time being set.
Operation
ON/OFF
FAN
MODE
TIMER
CLOCK
SET
SLEEP
LOCK
RESET
SWING
Operation Mode
1. In COOL,DRY mode
1 hours after SLEEP mode starts, temp. will
become 1
O
C higher than temp. setting. After
another 1 hours, temp. rises by 1
O
C further.
The unit will run for further 6 hours then stops.
Temp. is higher than temp. setting so that room
temperature won't be too Iow for your sleep.
SLEEP operation starts SLEEP operation stops
Approx.6hrs
1 hr
Rises 1
O
C
Rises 1
O
C
Temp.setting
Unit stop
In COOL, DRY mode
1 hr
Power Failure Resume Function
If the unit is started for the first time, the
compressor will not start running unless 3
minutes have elapsed. When the power
resumes after power failure, the unit will run
automatically,
and 3 minutes later the
compressor starts running.
3.
In AUTO mode
The unit operates in corresponding sleep
mode adapted to the automatically selected
operation mode.
4. In FAN mode
It has no SLEEP function.
When TIMER function is set , the quiet sleeping
function can't be set up .After the sleeping function
is set up,if user resets TIMER function, the sleeping
function will be cancelled; the machine will be in the
state of timing-on,if the two modes are set up at the
same time ,either of their operation time is ended
first ,the unit will stop automatically,and the other
mode will be cancelled.
5.
Note to the power failure resume:
press the sleep button ten times in five seconds
and enter this function after hearing four sounds.
And press the sleep button ten times within five
seconds and leave this function after hearing
two sounds.
When quiet sleeping function is set to 8 hours,
the quiet sleeping time can not be adjusted.
12
2.
In HEAT mode
1 hours after SLEEP mode starts, temp will
become 2
O
C lower than temp.setting. After
another 1 hours, temp decrease by 2 C
O
further. After more another 3 hours, temp.
rises by 1 C further. The unit will run for
O
SLEEP
operation starts
SLEEP
operation stops
1 hr
1 hr
3 hrs
3 hrs
Rises 1
O
C
Temp.setting
Unit stop
In HEAT mode
Decreases 2
O
C
Decreases 2
O
C
further 3 hours then stops. Temp. is lower
than
temp. setting so that room temperature
won't be too high for your sleep.
To Next Page
Loading...
