HEALTH Operation
HEALTH AIRFLOW Operation
Note:
1.After setting the health airflow function, the position of inlet 
2.In heating, it is better to select the       mode.
3.In cooling, it is better to select the        mode.
under the high air humidity, 
a phenomenon falling drips of 
5.Select the appropriate fan direction according to the actual 
Operation
SMART
The anion generator in the 
airconditioner can generate a 
anion in the air and also to kill 
sediment 
in the room and finally
the 
quantity of position and
Press HEALTH
disappears,the operation stops.
SMART
The setting of
2).Press the button of health airflow 
Avoid the strong 
airflow blows 
The cancel of 
Press the button of health airflow 
grills of the air conditioner are opened, and the unit 
 goes on working under the condition before the
setting of health airflow function.
After stopping, the outlet grille will close automatically.
AM
AM
lot of anion effectively balance
bacteria and speed up the dust 
clean the air in the room.
button
For each press,       is displayed 
Air conditioner starts health 
anion function operation.
Press HEALTH button for twice press,           
When indoor fan motor is running, it has healthy
process function. (It’s available under any mode)
When the fan in the indoor unit does not work,
the health lamp lights up, but the anion generator
does not release anion.
health airflow
function
1).Press the button of health airflow, 
        appears on the display. Avoid
the strong airflow blows direct to
the body.
again,        
appears on the display. 
direct to the body.
the health airflow 
Cannot pull direct the outlet grille by hand.
Otherwise,the grille will run incorrectly. If the grille
is not run correctly, stop for a minute and then start,
adjusting by remote controller.
Notice: 
Remote controller can memorize each operation
status. when starting it next time, just press ON/OFF
button and unit will run in previous status.
function 
and outlet grills is fixed.
4.In cooling and dry, using the air conditioner for a long time 
water occurs at the outlet grille .
conditions.
again, both the inlet and outlet 
6