HSU09/12XCK-SM
Operation
Sleep Operation
If the wind speed is high or middle before setting for the
sleep, set for lowing the wind speed after sleeping.
If it is low wind, no change.
4.Set the wind speed change when sleeping
Operation Mode
1. In COOL,DRY mode
SLEEP operation starts SLEEP operation stops
Approx.6hrs
1 hr
Rises 1
O
C
Rises 1
O
C
Temp.setting
Unit stop
In COOL, DRY mode
1 hr
2.
In AUTO mode
3. In FAN mode
It has no SLEEP function.
Note
When TIMER function is set, the sleeping function can’t be
set up .After the sleeping function is set u
p
,
TIMER function, the sleeping function will be cancelled; the
machine will be in the state of
timing-on.
1 hours after SLEEP mode starts,temp.will become
higher than temp.setting.After another 1 hours,
temp.risesby 1 futher .The unit will run for further
6 hours then stops Temp. is higher than temp.setting
so that room temperature won’t be too low for your
sleep.
The unit operaters in corresponding sleep mode
adapted to the automatically selected operation
mode.
O
C
1
O
C
if user resets
POWER/QUIET Operation
Press button to enter additional options, when
cycle display to , will flash. And then press
enter to sleep function.
(1)
POWER Operation
(2)
QUIET Operation
Note ˖
When you need rapid heating or cooling, you can use this function.
You can use this function when silence is needed for rest or reading.
During POWER operation, in rapid HEAT or COOL mode ,
the room will show inhomogeneous temperature distribution.
Long period QUIET operation will cause effect of not too
cool or not too warm.
Press QUIET button, the remote controller will show ,
and then achieve to the quiet function. Press again this
QUIET button , the quiet function will be cancelled.
Press button to enter additional options, when cycle
display to , will flash，and then press ,enter to
power function. When cancel the function, please enter
additional options again and to cancel power function.
24
To Next Page
Loading...
Need help?
General
