What to do if my Haier HW60-12829S fails to operate?
If your Haier Washer isn't operating, here's what to check: * Ensure the program has been started. * Verify the door is properly closed. * Make sure the machine is switched on. * Check the power supply. * Deactivate the child lock, if it's enabled.
How to reduce strong vibration while spinning in Haier HW60-12829S Washer?
To stop strong vibrations while spinning in your Haier Washer: * Remove all transportation bolts. * Ensure the appliance is on solid, level ground. * Check and correct the load weight and balance.
Why is my Haier HW60-12829S Washer draining constantly?
If your Haier Washer is not draining properly, it could be due to several reasons. Ensure the drain hose is correctly installed and not placed in water. The cause may be that the height of the drain hose is below 80 cm or the drain hose end could reach into water.
Why is my Haier HW60-12829S Washer spinning failing?
If spinning fails in your Haier Washer, check the machine load and laundry for unbalance and run a spinning programme again. The cause may be unbalance of laundry.
Why is there no water in my Haier Washer?
If your Haier Washer isn't filling with water, check the following: * Ensure the water tap is open. * Inspect the inlet hose for kinks. * Verify adequate water pressure. * Confirm the door is properly closed. * Ensure a consistent water supply.
What to do if my Haier Washer has a drainage failure?
To address drainage failure in your Haier Washer, unblock the drain hose and ensure it is properly installed. The issue may be that the drain hose is blocked or the drain hose end is higher than 100 cm above the floor level.
Why does my Haier Washer operation stop before completing wash cycle?
If your Haier Washer stops before completing the wash cycle, check both the power and water supply. The cause may be water or electric failure.
How to fix UNB error on Haier Washer?
If your Haier Washer shows a UNB error, it means there's an unbalanced load. To fix this, check and balance the laundry load in the drum and reduce the load if necessary.
Why does my Haier HW60-12829S operation stop for a period of time?
If your Haier Washer displays an error code or the operation stops for a period of time, consider display codes, reduce or adjust the load. It may also be because the programme performs soaking cycle or detergent is not appropriate or excessive use of detergent. You may need to cancel the programme and restart.
How to get rid of excessive foam in my Haier Washer?
If you notice excessive foam in the drum or detergent drawer of your Haier Washer, check the detergent recommendations and reduce the amount of detergent used.
General| Capacity | 6 kg |
|---|---|
| Spin Speed | 1200 RPM |
| Display Type | LED |
| Color | White |
| Loading type | Front loading |
To Next Page
