Haier HW70-14F2B User Manual

2929
•Yourmachinemayhaveeitherasingleinlet
(cold)ordoublewaterinlets(cold/hot)basedonits
specications.
White-cappedhoseshouldbeconnectedtocold
waterinletandred-cappedhosetohotwaterinlet
(applicableformachineswithdoublewaterinlets).
•Toeliminatewaterleaksinpointsofcontact,1or
2nutsareprovidedinthehosepackage(applica-
bleformachineswithdoublewaterinlets).
Fitthesenutstotheendsofnewwaterinlethoses
onthesideoftab.
•Mountnewwaterinlethosestoa¾˝,threaded
tab.
•Connectthewhite-elbowendofthewaterinlet
hosestothewhite-lteredwaterinletvalveonthe
rearsideofthemachineandthered-elbowendto
red-lteredone(applicableformachineswithdou-
blewaterinlets).
Tightenplasticpartsofthejunctionsusingyour
hand.
Inuncertainconditions,havetheconnectionworks
bedonebyaqualiedplumber.
•Flowofwaterwithpressureof0,1-1Mpawillal-
lowyourmachinetooperatemoreefciently.)(0,1
Mpapressuremeansthatmorethan8litresofwa-
terwillowthroughafully-opentapinoneminute.)
•Ensurethatpointsofcontactdonotleakbytap-
pingthetapcompletelyaftercarryingmakingthe
connections.
CHAPTER -3: INSTALLATION OF THE MACHINE
(WATER INLET HOSE CONNECTION)
3/4”
10mm

Haier HW70-14F2B Specifications

General

Brand	Haier
Model	HW70-14F2B
Category	Washer
Language	English