6
In on
Adjus ng the b om cover
Before removing the transpo on bolts, please fix
the bo
om cover to the bo om of the washing
machine. Lay down the machine (fig.1), screw off the
feet and adjust the bo
om cover with the four holes
corresponding to the screw holes of the feet. Then
screw the feet back on through the cover and fix it
thus securely to the bo
om of the machine (fig 2.).
It keeps out the dampness and reduces the noise.
Dismantle the transport on bolts
The transpo on bolts are designed for clamping an -
vib
on components inside of the washing machine during
the transpo
on process.
Remove the back cover.
Remove the four bolts on the rear side and take out
the syn
c stabilizers from within the machine.
Replace the back cover.
Fill the holes le by the bolts with blanking plugs.
Note:
When you replace the back cover, the convexity
must face to outside, and you have to insert the
back cover from the two gaps as shown in fig.5.
Keep the transporta on bolts and synthe c
stabilizers in a safe place for later use.
Adjus ng the feet
There are adjustable feet under the bo om of the washing machine. Before
use, they should be adjusted so that the machine is level. This will minimize
vibr
ons and thus noise during use. It will also reduce wear and tear. We
recommend using a spirit level to level the appliance. The floor should be as
stable and flat as possible.
Before Use
5.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
