Why is my Haier HW80-BD14979U1 not filling with water?
If your Haier Washer won't fill with water, check the water tap and ensure there is a water supply. Inspect the inlet hose for kinks and unblock the inlet hose filter if necessary. Also, check the water pressure and make sure the door is properly closed.
Why is my Haier HW80-BD14979U1 vibrating so much during spinning?
If your Haier Washer is vibrating strongly while spinning, remove all transportation bolts and ensure the appliance has a solid and leveled position. Check the load weight and balance.
What causes spinning to fail in a Haier Washer?
If spinning fails in your Haier Washer, check the machine load and laundry, then run a spinning program again. This is often caused by an unbalance of laundry.
What to do if my Haier HW80-BD14979U1 is leaking?
If your Haier Washer is leaking, open the drain pump to drain the water and then shut down the machine. Contact the After sales service.
How to fix a Haier HW80-BD14979U1 that fails to operate?
If your Haier Washer fails to operate, first check if the program has started and start it if needed. Ensure the door is properly closed and that the machine is switched on. Verify the power supply and deactivate the child lock if it's activated.
What to do if my Haier Washer is draining while filling?
If your Haier Washer is draining while filling, ensure the drain hose is properly installed and that its height is not below 80 cm. Also, make sure the drain hose end is not in water.
How to fix drainage failure in Haier HW80-BD14979U1 Washer?
If your Haier Washer experiences a drainage failure, unblock the drain hose and clean the pump filter. Ensure the drain hose is properly installed and that its end is not higher than 100 cm above the floor level.
How to resolve a drainage error in Haier HW80-BD14979U1 Washer?
If your Haier Washer experiences a drainage error where water is not fully drained within 6 minutes, clean the pump filter and check the drain hose installation.
What to do if Haier HW80-BD14979U1 Washer stops before completing wash cycle?
If your Haier Washer stops before completing the wash cycle, check the power and water supply.
Why does my Haier HW80-BD14979U1 operation stop for a period of time?
If your Haier Washer operation stops for a period of time, consider display codes. Reduce or adjust the load, or cancel the program and restart it. This issue can arise due to the load pattern or if the program is performing a soaking cycle.
Essential checks and precautions before operating the appliance for the first time.
Guidelines for safe operation during everyday use of the washing machine.
Safety precautions to follow during cleaning and routine maintenance procedures.
Critical safety instructions for the proper installation of the washing machine.
Explains the function of the Power, Programme Selector, and Start/Pause buttons.
Describes the operation of various function buttons like Delay, Auto Dose, Temp, Speed, etc.
Comprehensive table detailing washing programs, load capacity, temperature, spin speed, and functions.
Instructions for connecting the appliance to power and water supply.
Explains information codes, display codes, and troubleshooting steps for common errors.
Guidance on connecting the drain hose and fresh water inlet hose.
Steps for safely connecting the appliance to the electrical power supply.
To Next Page
General