What to do if my Haier HW80-BP12929 has a drainage failure?
If your Haier Washer isn't draining properly, start by unblocking the drain hose and cleaning the pump filter. Also, ensure the drain hose end is not higher than 100 cm above the floor.
Why does my Haier HW80-BP12929 fail to operate?
If your Haier Washer fails to operate, check that the programme has been started, the door is properly closed, and the machine is switched on. Also, verify the power supply and deactivate the child lock if it's activated.
How to stop strong vibration while spinning in Haier HW80-BP12929?
If your Haier Washer is vibrating excessively during spinning, make sure you've removed all transportation bolts. Also, ensure the appliance is on solid, level ground and that the machine load is correctly balanced.
How to fix drainage error in Haier HW80-BP12929?
To resolve a drainage error where water isn't fully drained within 6 minutes in your Haier Washer, try cleaning the pump filter and checking the drain hose installation.
How to solve lock error on Haier HW80-BP12929?
If you get a lock error on your Haier Washer, make sure that you shut the door properly.
Why is my Haier HW80-BP12929 Washer not filling with water?
If your Haier Washer isn't filling with water, first ensure the water tap is open and there's a sufficient water supply. Then, check for kinks in the inlet hose and unblock the inlet hose filter if necessary. Also, verify that the water pressure is at least 0.03 MPa and that the door is properly closed.
Why does my Haier HW80-BP12929 Washer operation stop before completing wash cycle?
If your Haier Washer stops before completing the wash cycle, check both the power and water supply to ensure there are no failures.
Why is my Haier Washer draining while being filled?
If your Haier Washer is draining while filling, ensure the drain hose is properly installed and that its height is not below 80 cm. Also, make sure the drain hose end is not in water.
What to do if water level not reached in Haier Washer?
If the water level isn't reached after 12 minutes in your Haier Washer, ensure the tap is fully opened and water pressure is normal. Also, check the drain hose installation in case it's self-syphoning.
How to prevent excessive foam floats in Haier HW80-BP12929?
If you observe excessive foam in your Haier Washer, you should check the detergent recommendation to ensure it is appropriate for your machine.
To Next Page
General