Why Haier HW80-BP16636 won't start?
Your Haier Washer might not start due to several reasons: * The program may not have been started yet, so check the program and start it. * The door might not be properly closed, so ensure it is. * The machine may not be switched on, so switch it on. * There could be a power failure, so check the power supply. * The child lock might be activated, so deactivate it.
What to do if Haier HW80-BP16636 is not draining?
If your Haier Washer is not draining, it could be due to a blocked drain hose or pump filter. Unblock the drain hose or clean the pump filter. Also, ensure that the drain hose end is not higher than 100 cm above the floor level by making sure the drain hose is properly installed.
Why does Haier HW80-BP16636 Washer vibrate strongly while spinning?
Strong vibrations during spinning in your Haier Washer can be caused by: * Transportation bolts not removed: Remove all transportation bolts. * Unstable appliance position: Ensure a solid ground and leveled position. * Incorrect machine load: Check the load weight and balance.
Why Haier HW80-BP16636 Washer spinning fails?
If the spinning fails in your Haier Washer, it might be due to an unbalance of laundry. Check the machine load and laundry, and then run a spinning program again.
What to do if Haier Washer is leaking?
If your Haier Washer is leaking, open the drain pump to drain the water and then shut down the machine. Contact the after sales service.
How to fix Haier Washer filling and draining at the same time?
If your Haier Washer is draining while being filled, it's likely due to the height of the drain hose being below 80 cm or the drain hose end reaching into the water. Ensure that the drain hose is properly installed and is not in water.
What to do if Haier HW80-BP16636 Washer won't fill with water?
If your Haier Washer is not filling with water, check the following: * Ensure the water tap is open. * Check the inlet hose for kinks. * Unblock the inlet hose filter if it's blocked. * Verify that the water pressure is at least 0.03 MPa. * Make sure the door is properly closed. * Ensure there is a water supply.
What to do if Haier Washer shows unbalanced load error?
If your Haier Washer displays an unbalanced load error, reduce the load.
Why Haier Washer is not draining water fully?
If water is not fully drained from your Haier Washer within 6 minutes, clean the pump filter and check the drain hose installation.
What causes lock error on Haier HW80-BP16636?
If you are getting a lock error on your Haier Washer, ensure that you shut the door properly.
General| Load Capacity | 8 kg |
|---|---|
| Spin Speed | 1600 rpm |
| Energy Efficiency Class | A+++ |
| Dimensions (H x W x D) | 84.5 x 59.5 x 54 cm |
| Weight | 70 kg |
| Display Type | LED |
| Number of Programs | 16 |
| Loading type | Front load |
| Noise level washing | 53 dB |
| Energy Rating | A+++ |
| Color | White |
| Programs | Cotton, Wool |
To Next Page