Haier HWD-D1200TXVE - User Manual

Questions and Answers

E
Evelyn KimAug 13, 2025
Why is my Haier HWD-D1200TXVE Washer vibrating so much during the spin cycle?
- S
  Scott WarnerAug 13, 2025
  If your Haier Washer vibrates excessively during the spin cycle, here's what might be happening: 1. **Packing Bolts:** Ensure all packing fixing bolts have been removed from the machine. 2. **Uneven Surface:** The washing machine might be on an uneven surface. Use a spirit level to check if the appliance is level and adjust accordingly. 3. **Overloading:** You may have overloaded the machine. Try reducing the amount of laundry to below the maximum level.
T
Tyler TaylorAug 17, 2025
Why is my Haier HWD-D1200TXVE not filling with water?
- S
  Stephanie PetersonAug 17, 2025
  If your Haier Washer isn't filling with water, consider these potential causes: * **Water Supply:** Make sure the water tap is fully turned on and that the water supply is connected to a domestic mains supply. * **Hoses:** Check the inlet hoses to ensure they are not bent or crushed, which could restrict water flow. * **Programme Selection:** Ensure the programme selection dial is correctly set. * **Door:** Verify that the door is properly closed.
K
Kelly GibsonAug 21, 2025
How to troubleshoot a Haier Washer that fails to operate?
- B
  brittneymckayAug 21, 2025
  If your Haier Washer isn't operating, here are a few things to check: * **Power Supply:** Ensure the washing machine is correctly connected to the power supply. * **Power Failure:** Check for a power failure in your home. * **Door:** Make sure the door is properly closed. * **Power On:** Verify that the machine has been switched on.
N
Nicolas SullivanAug 25, 2025
What to do if my Haier Washer has a drainage failure?
- A
  Allen RamirezAug 25, 2025
  If you're experiencing drainage failure with your Haier Washer, check the drain hose for blockages. Also, make sure that the end of the drain hose is not over 100cm above the floor level.
J
Jeffrey MartinAug 28, 2025
Why does my Haier HWD-D1200TXVE stop before the wash cycle is complete?
- M
  moorecatherineAug 28, 2025
  If your Haier Washer stops before completing the wash cycle, check the power and water supply. It may be that there has been a water or electricity failure. Also, the washing machine may be in soaking cycle.
J
jennifercohenSep 1, 2025
Why is my Haier HWD-D1200TXVE continuously filling and draining?
- D
  Derek BushSep 1, 2025
  If your Haier Washer is continuously filling and draining, check that the height of the drain hose is above 80cm, because the drain hose may be too low.
G
Gilbert HarrisSep 4, 2025
Why is there excessive foam in my Haier HWD-D1200TXVE drum?
- S
  steven64Sep 5, 2025
  If you notice excessive foam in the drum of your Haier Washer, it could be due to the type or amount of detergent you're using. Check that the detergent is a low foam type and reduce the amount of detergent used.
J
jamesbestSep 8, 2025
Why does my Haier HWD-D1200TXVE Washer operation stop for a period of time?
- S
  Sheri ReynoldsSep 8, 2025
  If your Haier Washer stops for a period of time, it may be in anti-crease soaking cycle. Wait until cycle is complete. Also, the washing machine may be giving an error message. See error messages on previous pages.

Summary

Parts Identification

Safety Instructions

Installation Steps

Preparation and Levelling

Steps to remove packing materials, transit bolts, and level the appliance.

Water and Power Connections

Guidance on connecting water supply, drain hose, and electrical power.

Control Panel Overview

Power Button

Description of the power button function.

Programme Selection Dial

Details on how to use the programme selection dial.

Detergent Drawer

Explanation of the detergent distribution drawer and its compartments.

Spin Speed Setting Button

Information on selecting the spin speed for the wash cycle.

Display Screen

Details on information shown on the washing machine's display.

Wash Status Indicator

Explanation of the indicator light showing the cycle stage.

Washing Machine Functions

Start;Pause Operation

How to start, pause, and resume wash programmes.

Eco Button Function

Explanation of the economy wash function for saving resources.

Dry Button

Details on using the dry function after the spin cycle.

Rinse Hold Function

How the rinse hold feature helps reduce creasing and odours.

Delay Start Button

Instructions for setting a delayed start for wash programmes.

Wash Temperature Button

How to select and adjust the wash temperature.

Programme Selection Guide

Preparing for a Cycle

Detergent Selection

Guidelines on choosing and using the correct detergent for the washing machine.

Laundry Treatment

Steps for sorting and preparing laundry before washing.

Using Your Appliance

Loading and Adding Detergent

Instructions on loading clothes and adding detergent/softener.

Programme and Function Selection

Guidance on selecting programmes, temperature, and functions.

Starting Wash and Energy Saving

Steps to start the wash cycle and tips for energy efficiency.

Other Functions

Control Panel Lock

How to lock and unlock the control panel to prevent accidental changes.

Power-off Memory Function

Explanation of the machine's ability to resume after a power interruption.

Error Display Messages

List and explanation of error codes and their solutions.

Maintenance Procedures

General Cleaning

Instructions for cleaning the machine case, detergent drawer, and filter.

Filter and Water Inlet Cleaning

Steps to clean the filter and water inlet to prevent blockages.

Troubleshooting Guide

Technical Specifications