6
Dismount the water inlet hose
Connection between the water inlet hose jointer and the water inlet hose
Check the connection between the water inlet hose jointer and the
water faucet
1.Swing the hose gently to check if it is fastened stably.
2.After installation, open the faucet to check if it leaks water.
3.Do not bend the hose by force.
4.Each time before using, please check if the connection
between the water inlet hose jointer and the water faucet,
and the installation of the water inlet hoseis firm, so as
to avoid dropping owing to improper installation.
1 Push down the slider. Plug the water inlet hose into the jointer.
2 Hang the lock lever onto the jointer. Release
the slider till a click sound is heard.
Lock level
Slider
The water inlet
hose jointer
Slider
Locking level
1 Close the water faucet.
2 Press the lock lever and push down the slider. Then pull off the
water inlet hose. If the machine is used more than once every
week, the water inlet hose jointer can remain on the faucet to
avoid damaging the fastening screws.
To Next Page
Loading...
Need help?
General
