HYCD-282/282A/282C_Service Manual
11
the display screen and the second digit flashes (the default temperature set for low temperature alarm is -5℃ in the cabinet).
If the set temperature is to be changed, press button “ ” to change the flashing digit and by pressing “ ”, value of
the currently flashing digit can be changed. After the setting is completed, the value set is stored. Temperature range set for
low temperature alarm: min. temperature displayed ≤temperature set for low temperature alarm- set temperature ≤-5 ℃, or
otherwise, set as the default value.
5. Temperature zone switch:
In the state of being unlocked, press the button “set”, “L0” is displayed on the display screen, press the button “temperature
zone switch”, “L0” is switched to be displayed on another display screen. At this time, related parameter on this display
screen can be set.
6. Setting delay in start-up
In the state of being unlocked, hold simultaneously buttons “set” and “temperature adjustment” for 5s, a delay time for the
refrigerating compressor is displayed, and by pressing the button “temperature adjustment’, the required time is set.
7. Setting stop of the refrigerator or the freezer:
In the state of being unlocked, press button “set”, and “L0” is displayed on the displayed panel. Then press “temperature
adjustment”, L5 is set, and press button “set” again. 1 flashes on the display screen (the default normal start/stop status of
the compressor), and if the refrigerator/freezer is to be stopped, press “temperature adjustment”, and “1” is changed into “0”.
The refrigerator/freezer cannot be used again until a change for “1” is done again.
8. Setting inquiry
In the state of being unlocked, press the button “set”, “L0” appears on the display screen and digit “0” flashes. Press
“temperature adjustment” to change it to 1, 2, 3, 4 or 5. press “set” again, a correspondent value is displayed. Among them,
L0 stands for temperature set in the cabinet, L1 stands for temperature set for high temperature alarm, L2 stands for
temperature set for low temperature alarm, L3 stands for the current voltage, L4 stands for the current ambient temperature
and L5 stands for state set for start/stop of the compressor.
9. Freezing defrosting:
In the state of being unlocked, by holding the button “freezing defrost” for over 5s, the freezer compressor stops, and “dF”
is displayed on the freezer display screen. Temperature inside the cabinet gradually rises and operation of the compressor
cannot automatically be restored. Only in the state of being unlocked, and by holding button “freezing defrost” for over 5s
can the freezer compressor be started again for normal operation.
10. Temperature calibration
In the Unlocked state，press and for 5s，the display panel will show‘0’and flashing(the adjust zone is -5 to 5)，Press
to change the display Zone between refrigerator and freezer area，Press to calibrate the temperature.
To Next Page
Loading...
