Haier IPD-01 User Manual

7
Preset EQ
Preset EQ
The unit provides4 preset EQsettings for yourselection.
In either iPad/iPhoneor AUX(auxiliary) mode :
- To select thepreset EQ, pressthe EQ buttonfrom the remotecontrol.
- Each pressof the EQbutton will scrollthrough following selection.
FLAT JAZZ
CLASSIC
ROCK POP
Care and Maintenance
- Do not subject the unit to excessive force, shock, dust or extreme temperature.
- Do not tamper the internal components of the unit.
- Clean your unit with a damp (never wet) cloth. Solvent or detergent should never be used.
- Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
- Keep your unit away from heating appliances and sources of electrical noise such as fluorescent
lamps or motors.
Resetting the Unit
If the unit experiences a power surge or electric shock, it is possible that the internal micro-controller
may lock up and the unit will not respond to any commands from the panel controls.
1.In this event, unplug and then reconnect the AC power plug into the wall outlet.
2.Use a straightened paper clip, toothpick or similar objects to press the RESET button located at the
rear of the Support Frame (see the below figure). The reset operation clears the system memory and all of
your previous settings will be erased.
CAUTION: DO NOT USE SHARP, POINTED OBJECT TO PRESS THE RESET
BUTTON. IT MAY DAMAGE THE RESET SWITCH INSIDE THE UNIT.
RESET button
C
M
Y
CM
MY
CY
CMY
K
EN7.pdf2010-11-1620:35:52

Haier IPD-01 Specifications

General

Interface	docking connector
Microphone in	Yes
USB 2.0 ports quantity	0
Number of speakers	2
Compatibility	iPad, iPhone, iPhone 3G, iPhone 3GS, iPhone 4, iPod Nano (1st, 2nd, 3rd, 4th, 5th, and 6th generation), iPod touch (1st, 2nd, 3rd, and 4th generation)
Product color	Black
Power consumption (typical)	5 W

Weight and Dimensions

Depth	198 mm
Width	177 mm
Height	210 mm
Weight	861 g