Haier IPD-01 User Manual

8
Technical Data
Power Adaptor : Input AC 100V - 240V ~ 50 / 60 Hz
Output DC 5V 3500mA
Power Supply for the unit : DC 5V 3500mA
Compliance with FCC Regulations
The equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against hamful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
enegry and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications.However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-
-
-
-
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/television technician for assistance.
THE SPECIFICATION AND EXTERNAL APPEARANCE OF THE SET ARE SUBJECT TO CHANGE
WITHOUT PRIOR NOTICE.
C
M
Y
CM
MY
CY
CMY
K
EN8.pdf2010-11-1620:37:13

Haier IPD-01 Specifications

General

Interface	docking connector
Microphone in	Yes
USB 2.0 ports quantity	0
Number of speakers	2
Compatibility	iPad, iPhone, iPhone 3G, iPhone 3GS, iPhone 4, iPod Nano (1st, 2nd, 3rd, 4th, 5th, and 6th generation), iPod touch (1st, 2nd, 3rd, and 4th generation)
Product color	Black
Power consumption (typical)	5 W

Weight and Dimensions

Depth	198 mm
Width	177 mm
Height	210 mm
Weight	861 g