REMOTE CONTROLLER
-9-
1
EXIT
TV
ENTER
HDMI
SLEEP
MIX
DISPLAY
PC
REVEAL HOLD
LIST
INDEX
SOUND
PIC
ASPECT
YPbPr
SUBPAGE
AV
AUTO
TEXT
SIZE
NICAM
RECALL
SOURCEMENU
2 3
4 5 6
7 8 9 0
+
CH
_
+
_
VOL
POWER
MUTE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
Insert Batteries Into the Remote Control
1 2
3
Remark:
1. Remove the battery cover.
2. Inserting the 2 AAA 1.5V batteries making sure the
polarity (+ or -) of the batteries matches the polarity
marks inside the unit.
3. Mount the battery cover.
Replace with new batteries when the TV set begins
to show the following symptoms:
Operation is unsteady or erratic. Sometimes the TV
set does not function with Remote Control Unit.
1) Alkaline Battery Recommended.
2) Remove batteries when they are exhausted or if the
remote control is not to be used for long time.
1:POWER
To set the TV to standby or power on.
2:NUMBER KEY:
For direct access to programmes. For a 2 digit
programme number, the second digit must be
entered before the dash disappears. The number
(in analog TV mode) is displayed for a few seconds.
3:MENU
To display the menu or return to the previous menu
4: CURSOR
To move within the menu.
5: EXIT
Used to exit menu.
6: VOL+/-
To adjust the sound level.
7: PIC
To switch the picture mode.
8: SLEEP
Set the time to turn off the TV.
9: SOURCE HOT KEYS
Switch to the source that you want
directly.
10:TELETEXT KEYS(see next page )
11:MUTE
To disable or enable the sound.
12: NICAM
To switch to nicam mode.only available in TV
programmes with nicam mode transmission.
13: RECALL
To access the previously viewed programme.
14: SOURCE
To display source menu .
15: ENTER
Confirms selection.
16: DISPLAY
Displays/removes the programme information.
17: SOUND
To switch sound mode.
18: CH+/CH-
To access the next or previous TV
Programmes.
19: ASPECT
To change the picture aspect ratio.
20: TEXT
To enter or exit TELETEXT.
21: AUTO
Auto adjust in PC mode.
To Next Page
Loading...
Need help?
General
