How to fix current detecting circuit abnormal of compressor module in Haier MRV 5-RC AB382MRERA Heat Pump?
If the current detecting circuit of the compressor module is abnormal in your Haier Heat Pump, replace the inverter control board with abnormal current detection loop.
What to do if four-way valve reversing failure in Haier MRV 5-RC AB382MRERA?
In case of a four-way valve reversing failure in your Haier Heat Pump, the suggested solution is to have it correctly replaced by after-sales service on site and ensure the refrigerant is sufficient.
How to fix outdoor compressor discharging temperature (Td1, Td2) too high failure in Haier Heat Pump?
If the outdoor compressor discharging temperature (Td1, Td2) is too high in your Haier Heat Pump, the suggested solution is to have the discharging temperature sensor replaced by after-sales personnel on site.
What to do for fan motor module hardware over current in Haier MRV 5-RC AB382MRERA?
If the fan motor module in your Haier Heat Pump experiences a hardware over current issue, the solution is to replace the fan motor.
What to do if radiator temp. sensor of compressor module is abnormal in Haier MRV 5-RC AB382MRERA?
If the radiator temperature sensor of the compressor module is abnormal in your Haier Heat Pump, replace the variable frequency board.
How to resolve AT24C04 EEPROM communication failure in Haier MRV 5-RC AB382MRERA?
To resolve AT24C04 EEPROM communication failure, AT24C04 EEPROM data check failure, or IM EEPROM data or communication failure in your Haier Heat Pump, replace EE.
How to fix emergency stop function switch failure in Haier MRV 5-RC AB382MRERA Heat Pump?
If the emergency stop function switch fails in your Haier Heat Pump, short circuit the CN18.
What to do if incorrect settings of quantity, address or capacity for outdoor unit in Haier Heat Pump?
If there are incorrect settings of quantity, address, or capacity for the outdoor unit of your Haier Heat Pump, the suggested solution is to research and lock the outdoor unit.
What to do if discharging temperature sensor Td1 and Td2 failure in Haier Heat Pump?
If the discharging temperature sensors Td1 and Td2 fail in your Haier Heat Pump, the solution is to have them correctly replaced by after-sales personnel on site.
What to do if outdoor unit compressor discharging temperature (Td1, Td2) too low failure in Haier Heat Pump?
If the outdoor unit compressor discharging temperature (Td1, Td2) is too low in your Haier Heat Pump, the suggested solution is to have the discharging temperature sensor replaced by after-sales personnel on site.
Lists the specifications for the one-by-four valve box.
Illustrates the piping connections for the one-by-four valve box.
Shows the electrical wiring connections for the one-by-four valve box.
Provides installation instructions and safety precautions for the one-by-four valve box.
Lists and explains error codes for outdoor and indoor units, aiding fault diagnosis.
Provides diagnostic flowcharts and steps for addressing common failure codes.
To Next Page
General