There may be some water flowing out of the drain
hose in the first use of the machine.
It is the water remained in the machine during the
ex-factory performance inspection.
Phenomenon Reason How to solve
The water faucet leaks water
There's abnormal sound inside
the machine
The machine
does not act.
The safety switch acts, and the spinning
cannot work. The wash, spin, jeans and
speedy s lamps are flashing.
Common phenomena
Phenomena Explanation
The spinning is intermittent when it starts.
The pulsator pauses during water filling in washing and rinsing.
It is to balance the laundries to avoid slanting.
The program is setting the drain time. A certain
period is needed before it starts spinning.
It is to avoid splashing during water filling.
Trouble-shootingAnswers to questions
The top lid is opened.
Is the drain hose blocked?
Are the laundries put slantingly?
Is the machine slanting?
Is the machine slanting?
Are there any foreign materials?
Are the laundries put slantingly in
spinning?
Is there power failure?
Is the power plug inserted tightly?
Is the water level reached preset
position?
Is the screw of the water inlet hose
jointer loose?
Is the screw of the water inlet hose
jointer twisted awry?
Close the top lid.
Clean the foreign material. Push
the start button again.
Reorder the laundries. Close the top lid.
Set the washing machine horizontally and
then open and close the top lid once.
Adjust the machine to be even
Remove the foreign materials.
Reorder the laundries and close the top lid.
Fasten the screw of the jointer properly.
Please use it when there's power supply.
Insert the power plug tightly.
Fill water to the preset position.
Push the SPIN button, but it doesn't act.
(If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns
sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special
maintenance department or after-sale service department of our company. Do not repair it by yourself.
Not wash
Not spin
Is the power plug inserted tightly?
Is the top lid closed reliably?
Are the laundries set flat?
Insert the power plug tightly.
Close the top lid.
Set the laundries flat.
No water inlet.
Is the power plug plugged tightly?
Is the water faucet opened?
Are the POWER ON/OFF and
START/PAUSE buttons pushed down?
Plug the power plug tightly.
Open the water faucet.
Push the power ON/OFF button and
START/PAUSE button.
The wash, rinse spin and gentle s lamps are
flashing. The machine does not spin.
The wash, rinse, spin and jeans s lamps are flashing.
The drainage cannot work, or is too slow.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
