Hakko Electronics FR-400 - Factory Default Settings Reset

● Password
You can change the password.
1. Move to “Password” and press the
<ENT> button.
2. Use the <↑> and <↓> buttons to enter
the current password, and press the
<ENT> button.
5. Press the <ENT> button to return to the
parameter setting screen.
3. Enter a new password.
(Selected a password that uses
3 characters from ABCDEF.)
4. After entering, press the <ENT> button.
Select “OK” or “Cancel” using the <↑> and
<↓> buttons.
21
<↑> <↓> <ENT>
  P assw o r d S e t
* * *
O K
<↑> <↓> <ENT>
  P assw o r d S e t
* * *
O K
<↑> <↓> <ENT>
 I n p u t P a s s w o r d
A * *
<↑> <↓> <ENT>
P ass. L o c k
P assw o r d
I n i t i a l R e s e t
ON
<↑> <↓> <ENT>
Read y A l arm
P ass . Lock
P assw o r d
ON
ON
6. PARAMETER SETTING (continued)
● Initial Reset
Initial Reset allows the factory default settings to be restored.
1.
Move the cursor to select “ Initial Reset ”.
After selecting, press <ENT>.
2. Using the <↑> or <↓> button, select
either “°C” or “°F”. To stop Initial Reset,
scroll the screen to select <EXIT>.
3. After selecting it, using the <↑> or <↓>
button, select “OK” or “Cancel”.




CAUTION
Even when Initial Reset is finished, “Pass. Lock” and password settings remain.



CAUTION
To exit from the parameter setting display, scroll the screen, select <EXIT>,
and press the <ENT> button.
<↑> <↓> <ENT>
Read y A l arm
P ass . Lock
Ini t i a l R e s e t
OFF
OFF
<↑> <↓> <ENT>
Ini t i a l R e s e t
ﾟ F
<↑> <↓> <ENT>
Ini t i a l R e s e t
ﾟ C
<↑> <↓> <ENT>
P ass . Lock
Ini t i a l R e s e t
<EXIT>
OFF
22