Hakko Electronics FR-810 - Page 7

F. Auto shutoff time setting
1. Auto shutoff time (30 minutes early) will be displayed if you press the button when is displayed.
2. Press the ( ) button, you can change to the desired value. Thevaluesyoucanenteris30to60(minutes).
3. The display will return to if you press the button after selecting.
G. Timer mode selection
1. Either  or will be displayed if you press the button when is displayed.
2. (OpenTiming) and (ClosedTiming) will be switched alternately If you press the
( ) button.
3. The display will return to if you press the button after selecting.
H. Forcedcoolingbypass
1. Either  or will be displayed if you press the button when is displayed.
2. and will be switched alternately If you press the ( ) button.
3. The display will return to if you press the button after selecting.
I. ChainPresetsetting
1. Either  or will be displayed if you press the button when is displayed.
2. and will be switched alternately If you press the ( ) button.
3. The display will return to if you press the button after selecting.
After changing parameters, press and hold the button down for at least two seconds until is displayed.
At this time, you can switch between and by pressing the ( ) button. Select if you
are finished making changes or if you need to go back and make more changes. Press the button to
confirm you selection.
Changes will not be completed until is displayed and you press the button.
Please note that no changes will be made if you turn off the power while making changes.
E. Password setting
1. Either  ,  or will be displayed if you press the button when is displayed.
2. If you press the ( ) button, (Open), (Partial) and (Restricted) will be
switched alternately.
3. If you press the button after selecting, the display will return to . ※1、2
※1 The display will move to the following selection screen if you select (Partial).
4. If you press the button at 3, you will be asked whether or not the password function is needed when
moving to the temperature setting mode.
5. Either (without password) or (with password) will be displayed if you press the ( ) button.
6. If you press the button after selecting, you will be asked whether or not the password function is
needed when moving to the preset selection mode.
7. Either (without password) or (with password) will be displayed if you press the ( ) button.
8. If you press the button after selecting, you will be asked whether or not the password function is
needed when moving to the offset mode.
9. Either (without password) or (with password) will be displayed if you press the ( ) button.
10. If you press the button after selecting, you will be asked whether or not the password function is
needed when moving to the Air flow mode.
11. Either (without password) or (with password) will be displayed if you press the ( ) button.
12. If you press the button after selecting, the display will move to password setting screen.
※2
If you select (Restricted), the display will move to the following password setting screen.
If you select (Partial), the display will move to the following the password setting screen after selecting ※１.
11. The hundreds digits in the display will begin to flash. It indicates that you can enter the value.
Press the ( ) button to enter the letter you required.
12. The tens digits in the display will begin to flash if you press the button after entering.
Use the same procedure to enter the letters for tens and units digit.
13. The display will return to if you press the button after entering the units digit.
6. PARAMETER SETTING