HAKO Hakomatic B 1100 User Manual

Folie 1
Hakomatic B 1100
(7580.02)
Service-Handbuch
Service-Booklet
Hako-Werke GmbH
.
Technisches Produktmanagement
.
D-23840 Bad Oldesloe
.
Stand 04/2006
Vertraulich – nur für den internen Gebrauch
.
For internal use only!
Schulung/Training
Fehlersuche/Trouble Shooting
Einstelldaten/Adjustments

HAKO Hakomatic B 1100 Specifications

General

Brand	HAKO
Model	Hakomatic B 1100
Category	Blower
Language	English

Summary

1. Safety and Operating Notes

2. General Machine Information

2.1 Machine Settings Overview

Details required and optional settings for machine configuration via control panel and modules.

2.2 Brief System Description

Overview of electronic modules controlling the machine and their basic functions.

3. Machine Configuration and Diagnostics

3.1 Machine Type Setting Procedure

Procedure for checking and setting the machine type using DIP switch A.

3.2 Option Settings Configuration

Configuration of machine options like cleaning agent, SWR, and side brush via DIP switch B.

3.3 LDS Battery Type Setting

Correctly setting the LDS based on battery type using DIP switch C.

3.4 Viewing and Deleting Last Error

Steps to view and clear the last recorded error code from the display.

4. Programming Cleaning Cycles

5. Program Function Definitions

6. Customer-Specific Setting Adjustments

6.1 Last Error Display Configuration

How to configure whether the last error is displayed upon machine startup.

6.2 Water Stage Selection Method

Procedure to set the water stage for cleaning based on user preference or default.

6.3 Cleaning Agent Control Setting

Configuration for turning the cleaning agent ON or OFF when water is activated.

6.4 SWR Switchover Setting

Setting for switching between clean water and soiled water recycling (SWR).

6.5 Side Brush Control Setting

Configuration for the side brush activation when 'scrubbing' is turned ON.

6.6 Filter Shaking Behavior

Setting for filter shaking behavior: continuous or interval-based.

6.7 Filter Vacuuming During Sweeping

Configuration for enabling or disabling filter vacuuming during sweeping.

6.8 Automatic Filter Shaking Post-Sweeping

Setting for automatic filter shaking upon termination of the sweeping process.

7. Module Configuration and Settings

7.1 Module 1 Settings

DIP switch settings and circuit breaker values for Module 1 (Power Electronic A5).

7.2 Module 3 Settings

DIP switch configurations and circuit breaker values for Module 3 (Power Electronic A4/A9).

8. Control Panel Settings

9. Water Pump Performance Data

10. Travel Drive Module Diagnostics

10.1 Signal Measurement Procedures

Detailed procedures for measuring signals and checking wiring for the drive control system.

11. Error Code Reference Chart