10
4.4.1 Using the buckle
● Put the two metal sections of the buckle connectors together.(g. 1)
● Slot the two buckle connectors into the slot in the top of the buckle until
they ‘click’ into place (g. 2)
● Check the harness is correctly locked by pulling the shoulder straps
upwards(g. 3 in pre. page).
● To release the harness, press the red button on the buckle downwards.
5. USAGE FOR AGE (GROUP II III)
The harness system must be removed from the seat (see point 5.1) when
used for these age groups 15kg-36kg .Only the 3-point vehicle belt system
can be used to buckle up the child car seat.
5.1 Removal of the harness
● Loosening the harness(see point 4.3), Turn the seat to the back.
● Slide both of the harness straps off the harness connector (Fig. 1).
● Slide the belt of the chest pads off the Chest pad connector (Fig. 2) .
● Pull the strap till the steel pole gets out of the solt (Fig. 3).
● Now you can remove the belts as well as the tongue in an upwards
direction (Fig. 4).
● Installation of the harness is carried out in reverse order to removal.
Keep harness with all parts in a safe place, to use in the future
To Next Page
Loading...
