Halfords 123 - Securing with Vehicles Belt

12
5. 3 Securing the child car seat with vehicle’s belt
The vehicle’s 3-point belt system may only be used to buckle up children of
the age groups II and III(15kg-36kg).
The harness system must be removed from the seat (see point 5.1) when
used for these age groups 15kg-36kg.
Step 1: Place the child safety seat on the vehicle’s seat ensuring it is rmly
pressed against the car seat backrest(Fig. 1).
Step 2: Seat your child in the child car seat (Fig. 2).
Step 3: Pull out the 3-point vehicle belt and place the lap belt on the
opposite side of the buckle under the arm rest. (make sure that the diagonal
belts and the lap belt on the buckle side are under the armrest) The lap
strap should be worn low down, so that the pelvis is rmly engaged and the
straps should not be twisted.
And allow it to the buckle in place. You will hear “click”(Fig. 3).
Step 4: Place the diagonal belt goes through the Head belt guide on the
side of the headrest. Make sure that the belt is not twisted.
Tighten the adult belt s in the direction as picture shows(Fig. 3) and
the diagonal shoulder belt in the direction of the automatic roll-up as
possible(Fig. 4).
The satisfactory position of the adult safety-belt buckle relative to the child
car seat is as the Fig 6. You can contact the child car seat manufacturer if in
doubt about this point.