27
The toilet
Don't pump dry.
Keep the valves for the outlet and the tank closed and the small lever to the right on the toilet on DRY
when the toilet isn’t in actual use. If you forget that, flush water may penetrate the bowl and seals are
exposed for overpressure, resulting in blackwater re-entering the bowl.
Don’t use cleaners that can be aggressive to the rubber in the toilet valves. Household detergents for
domestic toilets are for this reason usually not suitable in the toilets.
The HR 62 and 64 have electric toilets. A push button is located near the toilet which will activate the
electric pump. You do not need to change any valve on this boat. This toilet always pumps into the
holding tank. To empty the holding tank open the valve located close to the toilet.
Always close the valves after use. This is the only way to guarantee the toilet
to be water tight. Inform all users of the safety operation.
The holding tank
To close to the toilet bowl there are two handles operating the valves. Close these.
If you want to empty the tank: Open both handles. Do not discharge holding tanks close to shore.
Notice local environment laws and codes of good practise.
If you want to empty the bowl without emptying the tank: Open the lower valve but keep the upper
one closed.
Empty the tank as soon as possible, but no later than three days after use.
Warning
To Next Page
Loading...