Need help?Do you have a question about the Hallicrafters SX-140 and is the answer not in the manual?
General| Audio Output | 2.5 W |
|---|---|
| Power Supply | AC |
| Modes | AM, CW |
| Power Supply Voltage | 117 VAC |
| Power Supply Frequency | 60 Hz |
| Tubes | 6BA6, 6BE6, 6AQ5 |
| Image Rejection | 60 dB |
| Amateur Bands Range | 80, 40, 20, 15, and 10 meter bands |
Describes the SX-140's build, sensitivity, coverage, and key operational controls.
Lists specifications, band coverage, IF, and FCC limits.
Advice on careful operation and using calibration aids.
Guide for unpacking, selecting location, and connecting power.
Instructions for connecting single-wire and dipole antennas.
Explains FUNCTION, BAND SELECTOR, CAL-OFF, ANL-OFF, RF GAIN, AUDIO GAIN, SELECTIVITY-BFO, MAIN TUNING, CAL RESET, ANT TRIM.
Procedures for Standby, CW, SSB, and AM reception tuning.
Guide on how to use the carrier level meter for AM signal indication.
Instructions for replacing tubes, lamps, and removing the chassis.
Procedures for adjusting the carrier level meter and restringing the dial cord.
Details IF and oscillator alignment using crystals or signal generators.
A chart listing common problems, causes, and solutions for the receiver.
Lists capacitors, resistors, switches, tubes, coils, and other parts with their numbers.
To Next Page