Start-up
7100.006434_Bus description_PSD4xx_IO_G_ENG 6 17.08.2020
To turn on the PSD4xx, install the PSD in the correct position according to the instructions in
the installation manual. You can find information about installing the drive at the following
link: www.halstrup-walcher.de/technicaldocu
The PSD must be grounded before connecting it to the power supply cable. The grounding
cable must be connected to the correct position on the PSD4xx and to the ground potential
(e.g. machine base).
Note: The positioning system should be connected to the machine base using the
shortest possible cable. The minimum wire cross-section of the grounding cable is
1.5 mm².
Once the PSD has been grounded, it can be connected to the power supply and the
communication interface. The drive is now ready for operation.
To Next Page
Loading...
