halstrup-walcher PSD4 Series - 3 Description of IO-Link; Status Leds

Description of IO-Link
7100.006434_Bus description_PSD4xx_IO_G_ENG 7 17.08.2020
Tel. +49 7661 39 63-0
info@halstrup-walcher.com
www.halstrup-walcher.com
3 Description of IO-Link
Note: For the IO-Link interface, IEC 61131-9 Version 1.1.2 is used as the SDCI
protocol
3.1. Status LEDs
The following LEDs are located under the sealing plug:
Green LED (gn) = RUN
LED in accordance with
IO Link:
Off:
IO-Link communication not available
90% on, 10% off:
IO-Link communication available
Yellow LED (ye) = Display motor voltage
Off:
Motor voltage too low or too high
On:
Motor voltage OK
Flashing at 0.5 Hz
Motor voltage OK and drive in the delivery state (concerning the
values of all parameters and the position of the axis)