Hama DIR3020 - Search; Automatic Search; Manual Station Search; Presets; Assigning the Presets Shortcut Buttons

15
Note
By default, the "Strong stations only" method is selected.
10.2 Search /Automatic search
• Press [NAVIGATE/ENTER/VOLUME]tostart
astation search.
• The radio stops the search and starts playback when
it nds astation.
• Press [NAVIGATE/ENTER/VOLUME]again to continue
the search until the next station is found.
10.3 Manual station search
When you make station settings manually,you can dene
the desired frequency yourself and tune into stations that
wereignored during the automatic station search because
their signals weretoo weak.
• Press [back] to switch to the manual station setting.
• Turn [enter/navigate] (left: -0.05 MHz/ right: +0.05)
until you see the desired frequency.Wait amoment until
playback of the received station signal begins.
• Now press [back] again to leave the manual station
setting.
10.4 Presets
Youcan save up to 30 of your favourite stations for quick
and direct access.
10.4.1 Assigning the Presets shortcut buttons
• Set the station that you would like to save as afavourite
station preset.
• Once the station is playing, press and hold the relevant
shortcut button for around 3seconds.
• The selection will be conrmed by the display
showing "Preset (1-4, depending on shortcut key)
stored".
• During playback, the Preset memory slot is displayed at
the right-hand edge of the screen.
Note
Favourites cannot be deleted. If all 30 station memory
slots are lled and you wish to save anew station,
choose one of the occupied slots. The station in this slot
will be overwritten with the new station.
10.4.2 Calling up shortcut button presets
To callupapreset station, press the corresponding
shortcut button (2-5).
10.4.3 Assigning the list of presets (1-30)
• Set the station that you would like to save as afavourite
station preset.
• If the station is playing, press and hold [
] (3) for
approx. 3seconds until the Presets list opens up.
• Navigate to the preferred memory slot and conrm your
selection by pressing [NAVIGATE/ENTER/VOLUME](9).
• The selection will be conrmed by the display showing
"Preset (1-30, depending on storage space) stored".
10.4.4 Calling up astation from the Presets list (1-30)
• Press [
] to call up the Presets list.
•
Use [NA
VIGA
TE/ENTER/VOL
UME](9) to navigate
to the preferred station and conrm your selection by
pressing [NAVIGATE/ENTER/VOLUME].
10.5 Audio setting
Forsome stations with aweak signal, quality can
be slightly improved by playing them in mono quality.
Youcan enable this function in the menu, and the
radio will automatically switch to mono reception when
signal quality is poor.Tochange the audio setting,
proceed as follows:
• Press [
](4) to access the Settings menu.
• Use [NAVIGATE/ENTER/VOLUME](9) to navigate to
the "Audio setting" menu item.
• Conrm the selection by pressing [NAVIGATE/ENTER/
VOLUME]and choose your preferred setting.
11. Sleep
The radio has atimer function, which switches the radio
to standby mode after apre-dened length of time,
regardless of its operating mode.
• Press [
](4) to access the Settings menu.
• Use [NAVIGATE/ENTER/VOLUME](9) to navigate to
the "Main menu" menu item.
• Conrm the selection by pressing [NAVIGATE/
ENTER/VOLUME].
• Use [NAVIGATE/ENTER/VOLUME]tonavigate to the
"Sleep" menu item.
• Youcan set the timer value with [NAVIGATE/
ENTER/VOLUME].
• Conrm the setting by pressing [NAVIGATE/
ENTER/VOLUME].
• If the sleep timer is activated, this is indicated in the
playback screen by [
].