HAMILTON-H900 Quick Guide
Display overview
*dual limb, single use breathing circuits only
HAMILTON-H900
Alarm silence button
1 Press (if appropriate for alarm)
► Silence for 2 min
Power button
1 ON: Long-press > 3 s
► Device starts in invasive mode
► Briefly press to (de)activate standby
2 OFF: Long-press > 3 s
Auto mode
1 Press for default settings
► Invasive mode: 37°C
► Noninvasive mode: 31°C
► Temperature gradient: + 2°C,
(+ 3°C for infant breathing set)
Open temperature monitoring
window
1 Press to show temperature
a) At Y-piece
b) At chamber exit
c) Difference between a) and b)
2 Press again to close window
(Non)invasive mode
1 Press to switch between invasive
and noninvasive modes
Expiratory tube button
1 Press to start extra heating of
expiratory tube*
► Reduce condensate in expiratory tube
(white)
2 Press again to stop extra heating
Tube connection indicators
► Green: connection correct
► Orange: testing
► Red: disconnected or faulty
See the HAMILTON-H900 Instructions for use for detailed information.
To Next Page
Need help?
General
