Document #101-0079 10 11/30/17
MONTHLY - Depending on use
1. The platen assembly should be opened and cleaned regularly
2. To open the platen assembly:
• Unplug the changer
• Disconnect the 9-pin plug
• Remove the validator from the holder
• Loosen the 2 thumbscrews on both sides of the validator
• Carefully lift to open from the bill insert end of the validator
3. Clean rollers, heads, belts, and sensors with cotton swabs and rubbing alcohol
4. Close the platen assembly and re-tighten the LATCH STUDS. Loose LATCH STUDS may cause false error
codes.
YEARLY
The XE Validator should be serviced annually to maintain maximum performance.
THIS WORK SHOULD ONLY BE DONE BY A TRAINED TECHNICIAN.
V. MAINTENANCE
To Next Page