11
Owner’s Manual
LED Brightness
To restore the factory default settings of this unit, do the fol-
lowing:
① Press and Hold the “A
”, “B” and high “C” pedals(see the
diagram on the le ).
② Continue to hold the pedal keys and turn the power to
the unit “ON.”
e LED on the top panel will light momentarily then turn
o for a second, indicating that the unit's factory settings
have been restored.
Load Default Values
G
LED
1
2
3
4
56
7
8
Indicating
Note On
Always
“On”
LED
A
BC
This allows you to adjust the brightness level of the LED
on the top panel. You can select from “1” (dim, always on)
through “8” (bright, indicating Note On). e default setting
is “8.”
To change the LED Brightness, do the following:
① Press and HOLD the “G
” pedal key and the pedal cor-
responding to the brightness level you want (see the dia-
gram on the le ).
② Continue to hold the pedal keys and turn the power to
the unit “ON.”
e LED on the top panel will blink according to the value
you select, indicating that the LED brightness level has been
changed.
Master Tune
A
LED
442Hz
440Hz
is allows you to change the master tuning of the built-
in Sound Generator. You can select either “A=440Hz” or
“A=442Hz.” e default setting is “A =440Hz.”
To change the Master Tune, do the following:
① Press and HOLD the “A” pedal key and the pedal corre-
sponding to the master tuning frequency (see the dia-
gram on the le ).
② Continue to hold the pedal keys and turn the power to
the unit “ON.”
e LED on the top panel will blink three times, indicating
that the unit’s master tuning frequency has been changed.
To Next Page
Loading...
Need help?
General
