6. Finishing the
Installation
Step 1. Tuck connections neatly into
ceiling outlet box.
Step 2. Slide the canopy up to ceiling and
over the two crews on hanger bracket.
Rotate canopy clockwise. Next, while
holding the canopy with one hand, slide the
canopy cover over the screws and rotate
clockwise until tight. Note: adjust the
canopy screws as necessary until the
canopy and canopy cover are snug. (Fig. 16)
Figure 16
Outlet box
Hanger
bracket
Hanger
ball
Canopy
Canopy
cover
Figure 15
White (neutral)
White (neutral)
Green or bare
copper (ground)
White ("AC IN N")
White ("to motor N")
Ground
(green)
(Connect to
ground wire on
hanger bracket
if no house
ground wire
exists.)
Outlet box
Black (hot)
Black ("AC IN L")
Black ("to motor L")
Receiver
Blue ("for light")
Blue (light)
Black (motor)
Fan
Figure 13
Figure 14
Note: The transmitter only works within 40
feet from receiver.
Receiver
Hanger bracket
ON ON
To Next Page
Loading...
