l
6
Assembly (continued)
3
CHECKING THE TABLE
Once all of the bolts are in place, fully tighten the bolts using the hex wrench (CC) and the wrench (DD).
Turn the table right side up.
Place the umbrella cap (D) to the table top (A)
Ensure all connections are secure.
D
A
Care and Cleaning
For best results, clean the table with a damp cloth and dry thoroughly. This will help prevent mildew by removing dirt particles that
may accumulate.
Do not clean with abrasive materials, bleach, or solvents.
Store the table in a dry, sheltered place when not in use.
Keep the table away from
, extreme heat, freezing conditions, and inclement weather such as rain, hail, sleet, snow, or wind.
To Next Page
Loading...
Need help?
General
