HAMPTON BAY HBLG2504E - Installation Preparation Steps; Installation Kits Contents; Suggested Tool Requirements; Chassis Preparation Procedures

[
NO_ NAME _ PARTS Q'TY
t
2
3
4
5
6
7
8
9
_0
11
12
13
_o ................
15
FRAME CURTAIN 2
SUPPORT BRACKET 2
SILL BRACKET 2
LOCK NbT 4
SCREW ................................ 14
SCREW (TYPE B) 7
SCREW (TYPE C} 5
SCREW_I:£_oPJ 2
CARRIAGE BOLT 2
FOAM STRIP 1
FOAM SEAL 1
W!NDOW LOCKING BRACKET 1
DRAIN P_PE 1
FRAME GUIDE 2
FOAMoPE 1
_REWDRIVER(Phili_ and Flaead), RULER, KNIFE, HAMMER, PENCIL, LEVEL ]
PREPARATION' OF CHASSIS
;i_ Remove timescrew,s whMl fasten the canner a't _th
si_s and at the back.
Slide the unitfrom th_ _b,[r_t by gripping the base pan
handle and _ffing forward while bracing the cabinet.
,Cutthe widow sash seat to the _oper ler._th,
Pee] off #_ebacking and a_ch t_ Foam-Seal @ to t_
underside of the window _sh,
Remove timebacking from the top u_r guide Foam-PE
@ and attach it to the _ttom of the Up_,r Guide.
Aflach the u_r guide o_o thie lop of fl_ecabinet with 3,
Ty_ A screws _
]_ert t_ Frame Guides @ intothe bottom of th_
cabinet.
'_ I_ert tl_ Frame Curtain Oin_o t#_ Uipper Guide and
Frame Guides _[_.
Fasten the curtains to,thieunit with 10 Type
A _rews ($.D_
Uppe
(Type A)