Hamron 608-207 - Compressor; Inverter

EN
27
6. If the vehicle does not start, wait for at least 3 minutes and try again.
7. If the engine starts, set the power switch to the OFF position.
8. Disconnect the black negative cable (-) and put it away.
9. Disconnect the red positive cable (+) and put it away.
10. Recharge the built-in battery in the auxiliary starter as soon as possible.
COMPRESSOR
WARNING: The compressor can be run continuously for up to 10 minutes, then it needs to cool for
at least 10 minutes. When inating tyres, the pressure rises very quickly – pay attention.
Ination
1. Open the compressor compartment and pull out the air hose.
2. Place the nozzle over the valve and press it right down. Fold down the locking lever into the
locked position.
3. Start the compressor with the compressor power switch.
4. Monitor the air pressure on the manometer until the desired pressure is reached.
5. When the desired pressure has been reached, turn o the compressor with the power switch,
fold up the locking lever and disconnect the nozzle from the valve. Replace the hose in the
compressor compartment.
6. Use an adapter to inate beach balls, air mattresses, inatable boats etc.
INVERTER
• The inverter can supply 230VAC, 50 Hz, 200W.
• To protect the battery, the inverter is tted with undervoltage protection. If the voltage falls too
low, an alarm will be emitted and the inverted will be switched o. It will be reset automatically
when the battery voltage is higher.
• The inverter is tted with short-circuit protection, which switches o the auxiliary starter if the
connected equipment short-circuits.
• If the indicator light on the inverter comes on, check that the connected equipment is working
correctly and does not need too much power for the auxiliary starter. Also check the charge level
in the battery.
• The fuse trips in the following situations. Replace the fuse if necessary.
– If the connected equipment needs too much power.
– In the event of a short circuit in the connected equipment.
1. Set the inverter power switch to the ON position.
2. Insert the cable from the external equipment into the 230V outlet.
3. Start the external equipment.
4. The inverter can be switched o automatically or with the power switch.