Hand Held Products SV Series User Manual

™
User’s Guide
Quick Check® SV Series
Bar Code Scanner/Verifier

Hand Held Products SV Series Specifications

General

Drop Specification	Withstands multiple 6 ft. / 1.8 m drops to concrete
Connectivity	USB, RS-232, Keyboard Wedge, IBM 46XX, Wand Emulation
Interface	RS-232, USB, Keyboard Wedge
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Humidity	5% to 95% (non-condensing)

Summary

Chapter 4 - ScanView Installation and Setup

ScanView Setup Requirements and Installation

Hardware and software requirements and installation steps for ScanView.

PC Communication Port Configuration

Steps to connect and configure the PC serial port for ScanView.

Chapter 5 - Scanner Setup

Scanner Positioning and Alignment

Guidance on optimal scanner placement for accurate analysis.

Scanner Calibration Procedures

Steps for calibrating the SV unit for accurate readings.

Chapter 6 - SV Command Language

Data Match and Diagnostic Commands

Hardware, Label, and Output Configuration Commands

System Control and Mode Commands

Chapter 7 - ISO Parameter Grade Thresholds

ISO Bar Code Quality Grade Definitions

Definitions of ISO grades for various bar code quality parameters.

Chapter 8 - Technical Specifications

General Product Specifications

Physical, environmental, and laser scanner specifications.

Scanning Performance and Operation Modes

Chapter 9 - Maintenance and Support

Technical Assistance and Contact Information

Information on obtaining technical support and contact details.

Product Service and Limited Warranty

Details on product service, repair, and warranty terms.

Appendix A - SV Series Setup Hints - Scanning Distance and Angle

Setting Scan Distance and Angle