What does it mean when seven LEDs are lit on Handicare Scooter?
If seven LEDs of the LED bar are lit on your Handicare Scooter, it could be due to the throttle being held in during start-up or a speed potentiometer fault. Try restarting the scooter without pressing the throttle. If the problem persists, check or replace the speed potentiometer.
What to do if Handicare TROPHY 20 Scooter has a poor connection to the motor?
If your Handicare Scooter has a bad connection to the motor, check all connections between the controller and the motor.
What to do if Handicare TROPHY 20 neutral handle is in neutral position?
If your Handicare Scooter's neutral handle is in the neutral position, put it in the drive position. If the brake is malfunctioning, check the connections between the brake and the controller. If necessary, replace the brake.
What to do if Handicare TROPHY 20 Scooter throttle was held in during start up?
If the throttle was held in during start up or a speed potentiometer fault occurred, restart the Handicare scooter without pressing the throttle. Check or replace the speed potentiometer.
How to fix Handicare Scooter controller malfunctioning?
If the controller in your Handicare Scooter is malfunctioning, the suggested solution is to replace it.
What to do if Handicare TROPHY 20 Scooter controller security found a problem?
If the Controller security on your Handicare Scooter has identified a problem, switch off the scooter. Check all connectors and the condition of the batteries. If the LED bar continues flashing after switching the scooter back on, consult the manufacturer.
What does it mean when two LEDs are lit on Handicare Scooter?
If two LEDs of the LED bar are lit on your Handicare Scooter, it usually indicates a poor connection to the motor. Check all connections between the controller and the motor to ensure they are secure.
What does it mean if nine LEDs are lit on Handicare TROPHY 20?
If nine LEDs of the LED bar are lit on your Handicare Scooter, it indicates that the neutral handle is in the neutral position or the brake is malfunctioning. Put the neutral handle in the drive position. Check the connections between the brake and the controller. If necessary, replace the brake.
Why is the first red LED lit on my Handicare TROPHY 20?
If the first red LED of the LED bar on your Handicare Scooter is lit continuously, it usually means that the batteries need charging or there is a poor connection. Check all connections between the controllers and the batteries. If the connections are fine, try recharging the batteries.
Why is my Handicare TROPHY 20 driving so slowly?
If your Handicare Scooter is driving very slowly, it could be due to several reasons: * The battery voltage might be too low. Check the battery voltage as indicated on the ‘Battery indicator’. Recharge the batteries for eight hours and verify that the battery charger is functioning correctly. * The speed selector switch might be in the slow position. Turn the speed regulator knob to the right to increase the speed. * The motor might have overheated. Remove the ignition key and allow the scooter to cool down.
General| Overall Length | 127 cm |
|---|---|
| Overall Width | 64 cm |
| Overall Height | 112 cm |
| Turning Radius | 155 cm |
| Ground Clearance | 10 cm |
| Charging Time | 8 hours |
To Next Page
