H&S XRT Pro - 6.7 L Dodge Cummins High Sulfur

1-888-628-1730 • XRT Pro Installation Manual 29
2007.52009 6.7L DODGE CUMMINS HIGH SULFUR CALIBRATION
Power Levels
To adjust the Power Level, select Change Power Level from the
Main Menu and follow the on-screen instructions.
NOTE: The Power Level ratings listed may not be exact for your particular
vehicle. The listed ratings apply to the out-of-the-box tuning that H&S tuning
devices are shipped with. Any custom downloads may result in dierent rat-
ings and can be found at www.hsperformance.com/update-instructions.
Injection Timing
This option allows for the adjustment of the maximum al-
lowed injection timing. There are 5 dierent settings for the Injection Timing:
1 – 24 degrees
2 – 26 degrees
3 – 28 degrees (Default)
4 – 30 degrees
5 – 32 degrees
NOTE: The injection timing adjustment will aect ALL power levels. This option can only be adjusted during the
Install Download process.
Adjustable Throttle Response
This option allows for the adjustment of the throttle response. There are 3 dierent settings
for the Throttle Response:
1 – Stock Response
2 – Default Response
3 – High Response
Emissions Selection
Most 2007-2009 6.7L Cummins are equipped with an emissions system designed to run Ultra
Low Sulfur Diesel (ULSD) Fuel. If you have removed or modied this emissions system (or plan
to immediately after installing this device), proper tuning must be installed or the vehicle will
not operate correctly. Select REMOVED at this option for a modied emissions system and high
sulfur fuel use. Select PRESENT if your emissions system requires ULSD fuel.
Exhaust Emissions Equipment
When running ULSD tuning, it is required that all sensors located in the exhaust system stay
in place and plugged in, otherwise you may experience a Check Engine Light (CEL) and even
POWER LEVELS
Stock .................... 0 HP
Tow
.................... 60 HP
Street
............... 120 HP
Performance
.... 175 HP