27
7 Operation
7.1 Check before operation
In order for the safety truck operation and
keep the truck in good condition, before
starting the truck, you must check it carefully.
1) Oil leak and liquid leak check
Park the truck, and check the truck for
hydraulic oil, gear oil or electrolyte leak.
2) Fork check
Check the fork and see whether bended or
crazed.
3) Front/rear wheel check
Check the wheel and see whether there is
any crazed, damaged, or abnormal wearing.
Check the wheel fasteners for looseness.
Inspect whether there is rope on the wheel.
4) Check front fork and linkage
mechanism
Check the fork and linkage mechanism, see
whether bending or crazed.
Whether appear interfere when move,
movement point wear whether severe.
5) Hydraulic oil check
Open the hood
Loosen the hydraulic oil filler cap, pull out
dipstick, and check if the oil level within the
scales. Add oil when insufficient.
Close the hood
6) Battery check
– Check the battery cover board. See
whether the battery fixed reliably.
– Check the terminal for loose or damage.
Otherwise adjust or replace.
Turn on the key switch
7) Instrument display check
Refer to instrument part.
8) Lifting and lowering button
Press the lifting button and check the fork
lifting condition. Press the lowering button,
check the fork lowering condition. Check if
the lifting system has abnormal sound.
9) Forward and reverse running
condition
Tilt the handle to some degree, gradually
press the accelerator button to the outside of
the body with thumb, and inspect the forward
running condition; gradually press the
accelerator button to the inside of the body
with thumb, and inspect the reverse running
condition.
10) Brake system
To Next Page