12
While in normal measurement mode, press and hold the CFM/SETUP key for about
5 seconds until the meter enters the menu selection mode.
The following parameters can be set from the menu:
1. Auto-off feature: 20 minutes (default setting) or disabled;
2. Acoustic signal: enabled (default setting) or disabled;
3. Temperature unit: °C (default setting) or °F.
When entering the menu mode, the auto-off selection is entered. The LCD shows in
three subsequent screens “Auto”, “OFF” and “20” to indicate that the 20 minutes
selection is active, or “Auto”, “OFF” and “no” if the feature is disabled.
The user can toggle the selection by pressing CAL/SELECT or move to the next
step with CFM/SETUP.
The following selection is the acoustic signal, which is displayed on two subsequent
screens: “bEEP”, “OFF” when the feature is disabled, and “bEEP”, “On” when
the feature is enabled.
Press CAL/SELECT to toggle the selection and CFM/SETUP to move to next step.
At this point it is possible to set the temperature unit, by selecting “Unit”, “°C”
or “Unit”, “°F”.
Press CAL/SELECT to toggle the selection and CFM/SETUP to exit the menu selection
mode and return to normal measurement mode.
MENU SELECTION
To Next Page
Loading...
