14
BATTERY REPLACEMENT
The meter displays the remaining battery
percentage when turned on. When the level is
below 5%, the battery symbol on the bottom
left of the LCD blinks to indicate a low battery condition.
If the battery level is low enough to cause erroneous readings, the Battery
Error Prevention System (BEPS) turns the meter off. When the battery needs
to be replaced, remove the cover on the rear of the meter and replace the
rundown battery with a new one, while paying attention to the correct
polarity. Reattach the back making sure that the gasket is in place and
tighten the 3 screws to ensure a good seal.
Replacement should take place in a non-hazardous area using a 9V
alkaline battery.
To Next Page
Loading...
