Hanna Instruments MULTIPARAMETER ION SPECIFIC METERS - Page 28

28
ON
OFF
SET
MEASUREMENT PROCEDURES
• Turn the meter on by pressing ON/OFF.
• When the LCD displays "C101" keep SET pressed until the desired
parameter is displayed.
• Release the key and when the LCD displays
"- - -", it is ready.
• Refer to the manual pages below to measure the appropriate
parameter and for the required reagents:
FREE CHLORINE MEASUREMENT
• "Cl F" will appear on the LCD; then see page 34.
TOTAL CHLORINE MEASUREMENT
• "Cl t" will appear on the LCD; then see page 36.
pH MEASUREMENT
• "PH" will appear on the LCD; then see page 46.
IODINE MEASUREMENT
• "Id" will appear on the LCD; then see page 42.
BROMINE MEASUREMENT
• "br" will appear on the LCD; then see page 32.
CYANURIC ACID MEASUREMENT
• "CYS" will appear on the LCD; then see page 38.
LOW RANGE IRON MEASUREMENT
• "FE" will appear on the LCD; then see page 44.
C 101
pH/Cl/CYS/I/Br/Fe